Thread Starter![As511 protocol manual free As511 protocol manual free](/uploads/1/2/5/8/125841787/358482516.png)
Protocol Procedural Manual The following is intended to orient and assist the Permanent Missions in the various requests they need to make at the Department of State. All requests made to the Department of State, should be made through the OAS Office of Protocol (Protocol/OAS) which serves as a liaison between the Permanent Missions and the. Mar 23, 2004 The cable is also not standard pinouts to this port, you can get the pinouts from an S5-115U manual, as I recall there is only a 20mA loop available, and no standard RS232 port. It supports a protocol called AS511, along with a master/slave network called L1 (at least most of them did - some OLD versions of the processor didn't).
![As511 protocol manual free As511 protocol manual free](/uploads/1/2/5/8/125841787/358482516.png)
Lynn Linse
I'm starting a project to network into older Siemens equipment by serial port/protocol - specifically S5. Any suggestions of which protocol(s) will support the MOST old & new equipment. Multi-drop is NOT required - point-to-point is Ok. PC/DDE/OPC servers are irrelevant - I need to do the protocol work on a small embedded system to mount with the S5.
I've heard of things like AS511 and R3946, but am not a Siemens expert & want feedback as to what are common older protocols.
I repeat, the S7 are not in my scope yet - so PPI or MPI are not yet required.
Thanks
Lynn August Linse, Snr Prod App Engr
Lantronix
I've heard of things like AS511 and R3946, but am not a Siemens expert & want feedback as to what are common older protocols.
I repeat, the S7 are not in my scope yet - so PPI or MPI are not yet required.
Thanks
Lynn August Linse, Snr Prod App Engr
Lantronix